Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eaton XN300
Summary of Contents for Eaton XN300
- Page 1 XN300 switch XN-332-5ETH-UMS Instruction manual...
- Page 2 CONTENTS OF THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES. In no event will Eaton be responsible to the purchaser or user in contract, in tort (including negligence), strict liability or otherwise for any special, indirect, incidental or consequential damage or loss whatsoever, including but not limited...
-
Page 3: Table Of Contents
APPENDIX . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Approvals and national approvals for XN300 system devices ....7 Dimensions . -
Page 4: Safety Information
This manual contains important information regarding the operation and installation of the Active Voltage Conditioner. All operations on the Active Voltage Conditioner should be carried out by a trained technician familiar with the contents of this manual. InstructIon manual MN050011EN August 2022 www.eaton.com... - Page 5 Suitable safety hardware and software measures should • be implemented for the I/O interface so that cable or wire breakage on the signal side will not result in undefined states in the automation devices InstructIon manual MN050011EN August 2022 www.eaton.com...
-
Page 6: About This Manual
Symbols used in this manual have the following meanings: other languages by visiting our support center at: http://www .eaton .eu/documentation. DANGER Enter the search keyword XN300 into the quick search or WARNS OF HAZARDOUS SITUATIONS THAT RESULT IN SERIOUS enter the document designation, e.g., MN050011. INJURY OR DEATH. -
Page 7: Xn300 Switch Xn-332-5Eth-Ums
4-pin FMC 1.5/4-ST-3.5 connector. The XN300 switch XN-332-5ETH-UMS is an integral part of the XN300 system. It can be used to connect multiple network segments with its five ports and have the data Figure 1 . XN-332-5ETH-UMS front view packets coming into one of five Ethernet ports (X1–X5) -
Page 8: Ethernet Connections
FD (Full Duplex) LED that shows which data transfer Common mode is currently selected. The data transfer rate for the XN300 10/100BASE-T Ethernet switch is set automatically • depending on the data transfer rate required by the device with which it is currently communicating: 10 Mbit/s in •... -
Page 9: Installation
Figure 4 . Connecting the power supply Figure 2 . The XN300 slice modules must be installed in a horizontal position Dimensions in inches (mm) ... -
Page 10: Dismantling Xn-332-5Eth-Ums
DIN rail the DIN rail. Figure 8 . Place the XN-332-5ETH-UMS against the bottom edge of the DIN rail Step 7 . Check to make sure that the XN-332-5ETH-UMS is solidly mounted. InstructIon manual MN050011EN August 2022 www.eaton.com... -
Page 11: Connection Terminals
0.2–0.75 Ferrule d ≤ 2.8 24–16 Strip length Figure 10 . Ferrule with d2 = Maximum 2 .8 mm Ød NOTICE THE SPRING-CAGE TERMINALS CAN BE USED TO CONNECT ULTRASONICALLY SPLICED (ULTRASONICALLY WELDED) WIRES. InstructIon manual MN050011EN August 2022 www.eaton.com... -
Page 12: Connecting The Power Supply
(maximum 4 A) must be installed between the power DANGER supply and the device. IN SAFETY-RELEVANT APPLICATIONS, THE POWER SUPPLY USED TO POWER THE XN300 SYSTEM MUST BE A PELV POWER Figure 12 . Wiring the power supply SUPPLY UNIT. 24 Vdc... -
Page 13: Appendix
Appendix Figure 13 . Dimensions XN300 switch XN-332-5ETH-UMS—dimensions in inches (mm) Approvals and national approvals for XN300 0.16 system devices (4.0) XN300 system devices are approved for use in several countries and regions. Description standard Product standards IEC/EN 4.01 UL 508 (industrial control equipment) (101.8) -
Page 14: Technical Data
0.39 inch (10 mm) uninsulated ferrule 0.39 inch (10 mm) Flexible with 0.2–0.75 insulated ferrule Ferrule d ≤ 2.8 24–16 Ød Strip length Additional information General Xn-332-… Imprintable label MF 10/5 CABUR MC NE WS (Weidmüller) InstructIon manual MN050011EN August 2022 www.eaton.com... - Page 15 InstructIon manual MN050011EN August 2022 www.eaton.com...
- Page 16 Eaton 1000 Eaton Boulevard Cleveland, OH 44122 United States Eaton.com © 2022 Eaton All Rights Reserved Eaton is a registered trademark. Printed in USA Publication No. MN050011EN / Z26444 All trademarks are property August 2022 of their respective owners.
Need help?
Do you have a question about the XN300 and is the answer not in the manual?
Questions and answers