Strata Cix Systems - Toshiba Strata CIX LVMU Installation And Programming Manual

Installation
Installation
8. Still using CIX Program 200, program up the Strata CIX extensions that are to use Voice Mail.
Ensure the following is assigned to each extension using Voice Mail:
9. (Optional) Set up Call Record.
Ensure the following:
10. (Optional) Set up Voice Mail Call Monitor (Code 870) feature to any flexible key (CIX Program
205).
Step 1: Shut Down Strata CIX

Turn off the main power switch to the Strata CIX system.
Step 2: Install the LVMU

Strata CIX Systems

CAUTION! See cautions under "Step 1: Unpack and Inspect the LVMU" on Page 3 before
1. Set the battery jumper to the ON position. The jumper is located on the bottom, left corner of
the circuit card, as shown in
2. Locate the proper slot for the LVMU. (The LVMU can be installed in any Strata CIX slot.)
3. Insert the card into the appropriate slot, and apply firm, even pressure to ensure proper mating
of connectors.
Important!
CAUTION! Do not hit the board for proper seating. This can damage the LVMU
6
-
Assign the VMID code (FB 19) to match the User ID/Mailbox number allocated to that
extension.
-
Set the VM MW Center Port (FB 22) to be that of the Pilot Hunt Group number
assigned to the LVMU Voice Mail ports, (CIX Programs 209 and 218).
-
In CIX Program 205, assign "Call Record" (Code 630) to any flexible key, additionally
"Pause/Resume" (Code 640) can be optionally assigned to an additional flexible key.
-
In CIX Program 204, the Mailbox Selection (FB 23) set the recording to Manual or
Automatic as required
proceeding.
If the battery jumper on the LVMU is not placed in the ON position all new
programming will be lost if power to the system is interrupted or the LVMU is
removed from the cabinet.
components.
Figure 1.
LVMU Installation Guide 03/06