Wireless Network Projection - Epson LightScene EV-110 User Manual

8. If necessary, select IP Settings and press
9. Select your IP Settings as necessary:
• If your network assigns addresses automatically, select IP Settings and turn on the DHCP setting.
• If you must set addresses manually, select IP Settings, turn off DHCP, and then enter the
projector's IP Address, Subnet Mask, and Gateway Address as needed.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press
10. To prevent display of the IP address on the standby screen, turn off IP Address Display.
11. To connect the projector to the network using IPv6, select On as the IPv6 Settings option. Then
select the Auto Configuration and Use Temporary Address settings as necessary.
12. When you finish selecting settings, select Complete and follow the on-screen instructions to save
your settings and exit the menus.
13. Press the LAN button on the remote control.
The wired network settings are complete when you see the correct IP address on the LAN standby
screen.
Parent topic:

Wireless Network Projection

You can project over a wireless network. To do this, you must set up your projector and computer for
wireless projection.
After connecting and setting up the projector, install the projector software. You may need to install it
from a software CD, if included, or download the software and manuals as necessary.
Selecting Wireless Network Settings Manually
Selecting Wireless Network Settings in Windows
Selecting Wireless Network Settings on Mac
Setting Up Wireless Network Security
Using a QR Code to Connect a Mobile Device
Parent topic:
Related references
Additional Projector Software and Manuals
Optional Equipment and Replacement Parts
Wired Network Projection
Using the Projector on a Network
Enter.
Enter.
45