Do you have a question about the 61006 and is the answer not in the manual?
Questions and answers
Ron
February 4, 2025
I need the parts for the motor pull rope assembly for stark 61006 plate compactor
1 comments:
Mr. Anderson
February 10, 2025
The spare parts list in the manual includes components related to the recoil starter mechanism, such as the recoil assembly and spiral spring. You can refer to the replacement parts list in the manual (pages 8-13) for specific parts. For purchasing, you may need to contact customer support at (909) 628-4900 (Mon-Fri, 9 AM to 3 PM PST).
Page 1
Owner’s Manual PLATE COMPACTOR 61006/61007 Questions? Problems? Please call our customer support: (909) 628 4900 Mon-Fri 9am to 3pm PST WARNING To reduce the risk of injury,all operators and maintenance personnel must read and understand these instructions before operating, changing accessories, or performing maintenance on this power equipment.
CONTENTS without adequate instruction. Introduction………………………………………………………1 ENSURE all operators read, understand and follow Applications………………………………………………………1 the operating instructions. Functions and controls…………………………………………1 Accessories………………………………………………………1 SERIOUS INJURY could result form improper or Hazards and risks………………………………………………1-2 Operation……………………………………………………2-4 careless use of this machine. Care and preventive maintenance…………………………4-5 Specification……………………………………………………5-6 Plate compactors are heavy units and should should Transportation…………………………………………………6...
Start and stop Procedure DO NOT refuel the motor while it is in operation or hot. DO NOT refuel the motor in the vicinity of sparks, a Diesel Engine naked flame or a person smoking. 1.Open the fuel cock. DO NOT over fill the fuel tank and avoid spilling petrol when refueling.Spilled petrol or petrol vapour may ignite.If spillage occurs,ensure that the area is dry before starting the motor....
Petrol Engine Compaction of dry materials will be facilitated by moistening with a water hose fitted With a sprinkler. 1.Open the fuel tap by moving the fuel ON/OFF lever fully to the right. Excessive watering or water content will cause the 2.If starting the engine from cold, set the choke ON machine to stall....
Page 5
Inspection and other services should always be Check for loose screws including tightness. See Table 3 below(tightening torque),for re-tightening. carried out on hard and level ground with the engine shut down. TABLE 3. TIGHTENING TORQUE(in.kg/cm)Diameter Inspection and Maintenance Service Tables. Changing Vibrator Oil To make sure your plate compactor is always in good when changing the vibrator oil,remove the drain plug...
V-belts reduces power transmission efficiency, Vibrator causing weak compaction and reduces the life of the Frequency----- 5,500 vibration/min belt itself. Centrifugal force----- 13.0 kN Operation Mass: 61006/61007 84kgs Acoustic Noise(According to 2000/14/EC) 61006/61007 Measured sound power 102.2dB level Guaranteed sound power Figure2.V-Belt Tension...
Working Size(L×W×H): TRANSPORTATION 69×50×105cm 1.Always shut off engine when transporting machine. 2.Make sure lifting device has enough capacity to hold machine(see identification plate on machine for weight). 3.Use central lifting point(a)when lifting machine. 4.Trolley wheel(b)is used short distance transportation. TROUBLE SHOOTING SYMPTOM POSSIBLE CAUSES SOLUTION...
Page 8
ENGINE TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE SOLUTI0N Check gap.insulation or replace spark Spark plug bridging? plug. Difficult to start, "fuel is Carbon deposit on spark plug? Clean or replace spark plug. available, but no Check spark plug insulation, replace if Short 0circuit due to deficient PARK at spark plug"....
Need help?
Do you have a question about the 61006 and is the answer not in the manual?
Questions and answers
I need the parts for the motor pull rope assembly for stark 61006 plate compactor
The spare parts list in the manual includes components related to the recoil starter mechanism, such as the recoil assembly and spiral spring. You can refer to the replacement parts list in the manual (pages 8-13) for specific parts. For purchasing, you may need to contact customer support at (909) 628-4900 (Mon-Fri, 9 AM to 3 PM PST).
This answer is automatically generated