Volkswagen Passat 2011 Workshop Manual page 116

Passat 2011 ➤ , Passat Variant 2011 ➤
Communication - Edition 07.2019
– Fit the wheel centre mountings onto the wheel bolts on the rear
wheels. Wheel centre mountings are positioned and secured
in the adapters through »O-rings«.
Note
Place wheel centre mountings on wheels in such a way that no
»anti-theft wheel bolts«, if any, are connected to wheel bolt adapt‐
ers.
– Set paddles with the help of the clamping nuts in such a way
that they can move freely just above the floor.
Make sure the paddles can move freely.
– Position calibration unit - VAS 6350/4- behind vehicle When
doing this, make sure to adhere to the required distance of
1.5 m between the angle brackets of the calibration device and
the paddles on the wheel centre mountings of the rear wheels.
– Bring calibration device - VAS 6350/4- into the horizontal po‐
sition. Do this by turning the plastic feet under the calibration
unit until the air bubble in the spirit level is precisely in the
centre of the indicator -arrow-.
– Switch on laser on calibration unit -1- and align the entire cal‐
ibration unit so that the laser beam -2- hits the rear end of the
vehicle centrally above the VW badge.
– Switch on the linear laser - VAS 6350/2- for distance meas‐
urement by pressing the
appears and the laser is activated:
112
Rep. gr.91 - Communication
button. The following display
ON