Installing Hdd; Connecting With Exterior Device - Eneo IER-38R160005A User Manual

2.1

Installing HDD

How to install HDD in the device:
Attention
1 Always switch off and unplug the unit.
2 Unscrew with a screw driver (+) and open the unit cover.
3 Unscrew HDD set screws of the bracket to disassemble.
4 Install HDD in the HDD bracket.
5 Fix the HDD-installed bracket with the unit.
6 Connect a data cable and power cable with HDD.
7 Close the cover and tighten screws.
2.2

Connecting with Exterior Device

How to connect each port to rear section of the unit:
1 Place the unit in a stable flat surface.
2 Make a room between front/rear sides of the device not to break connectors.
Warning
3 Check to switch off and unplug the unit.
Warning
4 Connect input ports of IP camera .
Note
5 Connect audio input and output port with a mic and speaker.
Note
6 Connect a monitor with VGA or HDMI port.
User Manual
 Withdraw the mains plug before installing HDD to reduce the risk of injury or
electrical shock, or device malfunction.

Make sure to check the compatibility of HDD with the device.
Do NOT install the device too close to the wall. Protrusive connects rear the unit
may be forcedly curved or pressed, which cause fires, electric shocks, or injury.
Make sure to withdraw the mains plug before installing the device.
Connecting a camera port with the unit automatically detects the camera.
Assure regulations in the area whether recording to be legal or not.
7