Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Wacker Neuson PG1
Summary of Contents for Wacker Neuson PG1
- Page 1 Operator’s Manual Pump 5200025395 0115...
- Page 2 Wacker Neuson Production Americas LLC. Any type of reproduction or distribution not authorized by Wacker Neuson Production Americas LLC represents an infringement of valid copyrights. Violators will be prosecuted.
-
Page 3: Foreword
Use the separate Parts Book supplied with the machine to order replacement parts. If you are missing any of these documents, please contact Wacker Neuson to order a replacement or visit www.wackerneuson.com. When ordering parts or requesting service information, be prepared to provide ... - Page 4 The information contained in this manual is based on machines manufactured up until the time of publication. Wacker Neuson reserves the right to change any portion of this information without notice. The illustrations, parts, and procedures in this manual refer to Wacker Neuson ...
-
Page 5: Table Of Contents
Table of Contents Foreword Safety Information Signal Words Used in this Manual ............7 Machine Description and Intended Use ..........8 Safety Guidelines for Operating the Machine ........9 Service Safety ..................11 Operator Safety while Using Internal Combustion Engines ....13 Labels Label Locations .................. - Page 6 Table of Contents Technical Data Engine ....................28 Pump ....................28 Dimensions ..................29 AEM Safety Manual wc_bo5200025395_01_FM10TOC.fm...
-
Page 7: Safety Information
Safety Information Safety Information Signal Words Used in this Manual This manual contains DANGER, WARNING, CAUTION, NOTICE, and NOTE signal words which must be followed to reduce the possibility of personal injury, damage to the equipment, or improper service. This is the safety alert symbol. It is used to alert you to potential personal hazards. ►... -
Page 8: Machine Description And Intended Use
Safety Information Machine Description and Intended Use This machine is a centrifugal de-watering pump. The Wacker Neuson Pump consists of a gasoline engine, handle, frame, and an impeller with ports for water suction and discharge. The engine rotates the impeller during operation. Water is drawn into the pump through the suction port and expelled through the discharge port. -
Page 9: Safety Guidelines For Operating The Machine
To ensure safe operation of the machine: ■ Do not operate the machine if any safety devices or guards are missing or inoperative. ■ Do not modify or defeat the safety devices. ■ Only use accessories or attachments that are approved by Wacker Neuson. wc_si000920gb_FM10.fm... - Page 10 Safety Information Safe When operating this machine: operating ■ Remain aware of the machine’s moving parts. Keep hands, feet, and loose practices clothing away from the machine’s moving parts. When operating this machine: ■ Do not operate a machine in need of repair. Personal Wear the following Personal Protective Equipment (PPE) while operating this Protective...
-
Page 11: Service Safety
Machine When servicing or maintaining the machine: modifications ■ Use only accessories/attachments that are approved by Wacker Neuson. When servicing or maintaining the machine: ■ Do not defeat safety devices. ■ Do not modify the machine without the express written approval of Wacker Neuson. - Page 12 Safety Information Cleaning When cleaning and servicing the machine: ■ Keep the machine clean and free of debris such as leaves, paper, cartons, etc. ■ Keep the labels legible. When cleaning the machine: ■ Do not clean the machine while it is running. ■...
-
Page 13: Operator Safety While Using Internal Combustion Engines
Safety Information Operator Safety while Using Internal Combustion Engines WARNING Internal combustion engines present special hazards during operation and fueling. Failure to follow the warnings and safety standards could result in severe injury or death. ► Read and follow the warning instructions in the engine owner’s manual and the safety guidelines below. -
Page 14: Labels
Labels Labels Label Locations wc_gr012512 Label Meanings Danger Asphyxiation hazard. Engines emit carbon monoxide. Do not run the machine indoors or in an enclosed area. Warning Hot surface wc_si000921gb_FM10.fm... -
Page 15: Operation
1. Make sure all loose packaging materials have been removed from the machine. 2. Check the machine and its components for damage. If there is visible damage, do not operate the machine! Contact your Wacker Neuson dealer immediately for assistance. -
Page 16: Machine Components
Operation Machine Components Machine Components Descriptions Ref. Description Ref. Description Handle Primer button Priming plug Throttle lever Discharge port Stop switch Suction port Starter grip Drain plug Choke lever wc_tx003931gb_FM10.fm... -
Page 17: Recommended Fuel
Before using an oxygenated fuel, confirm the fuel’s contents. Some states and provinces require this information to be posted on the fuel pump. The following is the Wacker Neuson approved percentage of oxygenates: ETHANOL - (ethyl or grain alcohol) 10% by volume. You may use gasoline containing up to 10% ethanol by volume (commonly referred to as E10). -
Page 18: Refueling The Machine
Operation Refueling the Machine ■ Machine shut down Requirements ■ Engine cool ■ Machine/fuel tank level with the ground ■ Fresh, clean fuel supply Procedure Perform the procedure below to refuel the machine. WARNING Fire hazard. Fuel and its vapors are extremely flammable. Burning fuel can cause severe burns. -
Page 19: Positioning And Preparing The Machine For Operation
Operation Positioning and Preparing the Machine for Operation WARNING Personal injury hazard. Failure to follow the listed procedures may cause injury to personnel or damage to the machine. ► All persons setting up the machine must be fully trained on the installation of the machine. -
Page 20: Before Starting
Operation Continued from the previous page. Submerge the 4. Submerge the suction hose. hose ■ Always keep the strainer suspended in the liquid being pumped. ■ Do not run the pump in less than 100 mm (4.0 in.) of water. At this level and lower, water begins to form a funnel down to the bottom of the suction line and strainer, allowing the pump to draw in air. -
Page 21: Starting, Operating, And Stopping The Machine
Operation Starting, Operating, and Stopping the Machine ■ Suction and discharge hoses properly attached and positioned Requirements ■ There is fuel in the tank ■ Machine is primed Starting the Perform the procedure below to start the machine. machine 1. Set the throttle lever (a) to the low speed position. 2. - Page 22 Operation Continued from the previous page. 6. If the choke lever was moved to the CLOSED position, gradually move it to the OPEN position as the engine warms up. 7. Allow the machine to warm up in the low speed position for a few minutes. Note: The machine will begin to pump water with the throttle lever set in the low speed position.
-
Page 23: Emergency Shutdown Procedure
Operation Emergency Shutdown Procedure If a breakdown/accident occurs while the machine is operating, follow the procedure below. 1. Stop the engine. 2. Remove the obstruction. 3. Unkink the hoses. 4. Allow the machine to cool. 5. Contact the rental yard or machine owner. wc_tx003931gb_FM10.fm... -
Page 24: General Maintenance
Wacker Neuson. The use of service parts that are not equivalent in performance and durability to authorized parts may impair the effectiveness of the emission control system and may have a bearing on the outcome of a warranty claim. -
Page 25: Engine Maintenance: Subaru/Robin Eh025
Engine Maintenance: Subaru/Robin EH025 Engine Maintenance: Subaru/Robin EH025 The information in this chapter comes from copyrighted Subaru material. The viscosity of the engine oil is an important factor when determining the correct engine oil to use in your machine. Use an engine oil of appropriate viscosity based on the expected outside air temperature. - Page 26 Engine Maintenance: Subaru/Robin EH025 The engine maintenance schedule(s) in this chapter are reproduced from the engine owner’s manual. For additional information, see the engine owner’s manual. Periodic Maintenance Schedule table Every 8 hours Every Every Maintenance Items (daily) 50 hours 200 hours Check for leakage from hoses and tting (Daily)
-
Page 27: Troubleshooting
Troubleshooting Troubleshooting Problem / Symptom Cause Remedy ■ ■ Engine does not start. No fuel in tank Add fuel. ■ ■ Old fuel Drain fuel tank, change fuel filter, and fill with fresh fuel. ■ Add engine oil. ■ Engine oil pressure/oil level low ■... -
Page 28: Technical Data
Technical Data Technical Data Engine Machine Engine type Single cylinder, 4-stroke, air cooled, gasoline engine Engine make Subaru Engine model EH025, Tier 3 Displacement L (in 0.02 (1.49) Maximum rated power @ rated kW (hp) 0.81 (1.1) @ 7,000 rpm speed Operating speed (maximum) 7,000 ±... -
Page 29: Dimensions
Technical Data Dimensions mm (in.) 320.1 mm (12.6 in.) 218.4 mm 335.3 mm (8.6 in.) (13.2 in.) wc_gr012486 wc_td000640gb_FM10.fm... - Page 30 Technical Data Notes wc_td000640gb_FM10.fm...
- Page 44 Wacker Neuson Production Americas LLC, N92W15000 Anthony Ave., Menomonee Falls, WI 53051 Tel. : (262) 255-0500 Fax: (262) 255-0550 Tel.: (800) 770-0957 Wacker Neuson Limited - Room 1701–03 & 1717–20, 17/F. Tower 1, Grand Century Place, 193 Prince Edward Road West, Mongkok, Kowloon, Hongkong.