SOMFY MAESTRIA 50 RTS Quick Programming Manual

QUICK PROGRAMMING GUIDE FOR MAESTRIA™ 50 RTS MOTORS
IMPORTANT TO NOTE: Programming screens should not be inactive for more than 2 minutes or motor
will exit PROGRAMMING MODE. In which case you will need to start from Step 1.
1. INITIATE PROGRAMMING
On the transmitter, press briefly both
UP and DOWN simultaneously:
the screen jogs.
INSTALLER TIP: It is the same
procedure as with Altus motors.
NOTE: If hand-held transmitter direction is not properly programmed, Eolis/Soliris RTS sensor will not function in the manner it was intended.
Damage to the screens and injury may occur as a result.
3. PROGRAMMING MODE - MANUAL ADJUSTMENT
1) Position the screen at
the desired UPPER Limit
2) Press MY and DOWN
simultaneously: the
screen lowers.
OBSTACLE DETECTION - CHANGE THE LEVEL OF DETECTION OR DEACTIVATE
When programming, all button presses must be completed within 2 seconds of the previous press.
This function gives the possibility to deactivate the obstacle detection or increase the sensitivity up from the default level during the
downward movement.
1. ENTER THE OBSTACLE SETTING MODE
Move the screen to half-way position, press MY
and UP briefly and again MY and UP until the
screen jogs.
2. CHANGE THE OBSTACLE DETECTION LEVEL
If the actuator goes back to USER MODE (short jog) repeat Step 1.
To Deactivate:
Press UP briefly within 2 seconds
and then press UP briefly again.
The sceen will jog slowly and is
now deactivated.
IF THE JOG IS SHORT YOU'VE
REACHED THE DEFAULT SETTING.
TO DEACTIVATE PRESS UP AGAIN.
3. CONFIRM THE NEW SETTING & EXIT THE SETTING MODE
Press MY/STOP until the screen jogs to confirm the new setting.
The registered level of Obstacle Detection will be reached when entering Step 1 again.
For more information please visit www.somfysystems.com/Maestria
Copyright © Somfy SAS 10/2018
MANUAL SETTING OF THE END LIMITS
▶
SHORT JOG
3) Position the screen at
the desired LOWER Limit.
4) Press MY and UP
simultaneously: the
screen raises.
SCREEN HALFWAY
LONG JOG
P-0030
2. CHECK THE DIRECTION OF OPERATION
Check the direction of rotation by
pressing UP or DOWN. If necessary
change the direction of rotation by
simply pressing and holding the MY
button until the screen jogs.
5) Press MY until the screen jogs
to validate the end limit setting.
6) Briefly press the programming
button on the back of the
transmitter with a paper clip:
the screen jogs.
▶
THEN
BRIEFLY
To Increase Sensitivity:
Press DOWN briefly within 2 seconds
and then press DOWN briefly again.
The sceen will jog slowly and is now
more sensitive.
IF THE JOG IS SHORT YOU'VE REACHED
THE DEFAULT SETTING. TO INCREASE
SENSITIVITY PRESS DOWN AGAIN
▶
SHORT JOG
▶
SHORT JOG
▶
HOLD SHORT JOG
LONG JOG