SOMFY RTS MAESTRIA 50 Quick Programming Manual

QUICK PROGRAMMING GUIDE FOR MAESTRIA
IMPORTANT TO NOTE: Programming screens should not be inactive for more than 2 minutes or motor
will exit PROGRAMMING MODE. In which case you will need to start from Step 1.
1. INITIATE PROGRAMMING
On the transmitter; press briefly both
UP and DOWN simultaneously:
the screen jogs.
INSTALLER TIP: It is the same
procedure as with Altus motors.
NOTE: // hand-held transmitter direction is not properly programmed, Eolis/Soliris RTS sensor will not function in the manner it was intended.
Damage to the screens and injury may occur as a result.
3. PROGRAMMING MODE - MANUAL ADJUSTMENT
1) Position the screen at
the desired UPPER Limit
2) Press MY and DOWN
simultaneously: the
screen lowers.
OBSTACLE DETECTION - CHANGE THE LEVEL OF DETECTION OR DEACTIVATE
When programming, all button presses must be completed within 2 seconds of the previous press.
This function enables the obstacle detection sensitivity to be increased, decreased, or deactivated.
1. ENTER THE OBSTACLE SETTING MODE
Move the screen to half-way position, briefly
press MY and UP simultaneously, then hold
MY and UP simultaneously until the screen
Jogs.
2. CHANGE THE OBSTACLE DETECTION LEVEL
If the actuator goes back to USER MODE (short jog) repeat Step 1.
To Deactivate:
Within 2 seconds of the previous step,
press UP twice. The screen will jog
and is now deactivated.
IF A SHORT JOG OCCURS, YOU HAVE
REACHED THE DEFAULT SETTING.
TO DEACTIVATE PRESS UP AGAIN.
3. CONFIRM THE NEW SETTING & EXIT THE SETTING MODE
H
old MY until the screen jogs to confirm the new setting.
The registered level of Obstacle Detection will be reached when entering Step 1 again.
For more information please visit www.somfysystems.com/Maestria
Copyright © Somfy SAS 10/2018
MANUAL SETTING OF THE END LIMITS
Q
O
►
e
SHORT JOG
3)
Position the screen at
the desired LOWER Limit.
4) Press MY and UP
simultaneously: the
screen raises.
SCREEN HALFWAY
Q
0
0
LONG JOG
P-0030
50 RTS MOTORS
™
2. CHECK THE DIRECTION OF OPERATION
Check the direction of rotation by
pressing UP or DO WN. If necessary ,
change the direction of rotation by
holding MY until the screen jogs.
H
5) old MY until the screen jogs
to validate the end limit setting.
6) Briefly press the programming
button on the back of the
transmitter with a paper clip:
the screen jogs.
"
0
►
THEN
:)
BRIEFLY
To Increase Sensitivity:
Within 2 seconds of the previous step,
press DOWN twice. The screen will jog
and is now more sensitive.
IF A SHORT JOG OCCURS, YOU HAVE
REACHED THE DEFAULT SETTING. TO
INCREASE SENSITIVITY PRESS DOWN
AGAIN
SHORT JOG
RadloTechnology!i<lmty
0
O
►
0
SHORT JOG
C
0
0
"
0
►
')
HOLD SHORT JOG
0
0
e
LONG JOG