Table of Contents
Advertisement
3. The Configuration of the serial port
The debug serial port configurations are shown as below
Items
Bund Rate
Data Bits
Parity
Stop bits
Flow control
4. Lark Board Boot-up
Complete the above configurations, connect a HDMI/VGA monitor to Lark Board, and
then power on the board, Lark Board will boot the system from eMMC
Note:
Disconnect TF card to Lark bard when booting from eMMC
For more information of Lark board, please refer to:
http://www.embest-tech.com/product/pinggubanxilie/lark-board-evaluation-board.html
www.rocketboards.org
Visit
element14 is a trademark of Premier Farnell plc ©2014 Premier Farnell plc. All Rights Reserved.
3
Figure 2
Value
115200
8
None
1
None
for the related board.
Lark Board Quick Start Guide
：
Advertisement
Table of Contents
Need help?
Do you have a question about the Altera Lark Board and is the answer not in the manual?
Questions and answers