Black & Decker BDjig520 Original Instructions Manual page 8

English
(original instructions)
Attaching Rip Fence (figs. F & G)
Insert rip fence (14) into the shoe plate slots with the cross
u
bar facing down as shown in figure F.
Place screw (15) into hole in bottom of shoe plate.
u
Align clamp bar (16) over screw with lipped edge facing
u
down and pointing towards the rear of the saw.
Using a phillips screwdriver, run the screw into the
u
threaded hole in the bar clamp as shown in figure G.
Adjust to width of cut and tighten screw.
u
Circle Cutting (fig. H)
Insert rip fence into slot on the right side of shoe plate with
u
cross bar facing up.
Adjust rip fence so that distance from blade to hole in
u
cross bar is the desired radius and tighten screw.
Place saw so that centre of hole in cross bar is over
u
centre of circle to be cut (make plunge cut, drill hole for
blade or cut inward from edge of material to get blade
into position).
When saw is properly positioned, drive a small nail
u
through hole in cross bar into exact centre of circle to
be cut.
Using rip fence as a pivot arm, begin cutting circle.
u
Plunge Cutting (fig. I)
A plunge cut is an easy method of making an inside cut. The
saw can be inserted directly into a panel or board without first
drilling a lead or pilot hole. In plunge cutting, measure the
surface to be cut and mark clearly with a pencil.
Next tip the saw forward until the front end of the shoe sits
firmly on the work surface and the blade clears the work
through its full stroke. Switch the tool on and allow it to attain
maximum speed. Grip the saw firmly and lower the back
edge of tool slowly until the blade reaches its complete depth.
Hold the shoe flat against the wood and begin cutting. Do
not remove blade from cut while it is still moving. Blade must
come to a complete stop.
Maintenance
Your BLACK+DECKER tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.
Regularly clean the ventilation slots in your tool using a
u
soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
u
not use any abrasive or solvent-based cleaner. Never let
any liquid get inside the tool and never immerse any part
of the tool into liquid.
Mains plug replacement (U.K. & Ireland only)
If a new mains plug needs to be fitted:
Safely dispose of the old plug.
u
Connect the brown lead to the live terminal in the
u
new plug.
Connect the blue lead to the neutral terminal.
u
8
@
Warning! No connection is to be made to the earth
terminal. Follow the fitting instructions supplied with
good quality plugs. Recommended fuse: 5 A.
Protecting the environment
Z
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing demand for raw materials.
Please recycle electrical products and batteries according
to local provisions. Further information is available at
www.2helpU.com