Amino Kamai 7B User Manual

Kamai 7B User Guide
Contents
The Kamai 7B is supplied with the correct power adapter for your
local system. The package may also contain optional accessories
shown below, depending on your service provider.
The Kamai 7B is protected with a clear plastic film. This should be
removed before use.
Optional accessories
HDMI cable
Ethernet cable
3.5 mm jack to
3 x RCA cable
Remote control
and batteries
1. Overview of the Kamai 7B
1. Power/Activity LED:
Blue = on.
Blue flashing = IR command received.
Red = standby.
2. Wi-Fi signal strength indicator.
1. RF antenna or cable input
(optional).
2. Analogue A/V output.
3. Ethernet port.
4. HDMI output.
5. USB port.
6. S/PDIF optical output.
7. DC power in 12 V 2 A.
8. WPS button.
9. On/off switch.
10. Reset button. No function
in normal use. Only use
under guidance from your
service provider.
11. Smart card port for users
with SIM format smart cards
(optional).
Important - Safety instructions
Read these instructions carefully and keep for future reference. Note all
warnings.
The product contains no user-serviceable parts. Refer all servicing to qualified
service personnel.
Handle the product with care and do not attempt to dismantle the product.
Do not expose the product or its accessories to any liquids, rain or moisture.
Do not locate the product near a heat source and do not block ventilation
holes: the product will become warm during operation. Allow at least 10 cm
(4") around the product for air circulation.
Do not locate the product where it may be subject to physical shock, vibration
or where the product may fall over.
Do not place the product on soft furnishings or carpets.
Only use the power supply provided by the manufacturer. The use of any
other type of power supply may invalidate any approval or warranty applying
to the product and may be dangerous. If the power supply does not match
your local system, contact your product supplier.
Protect the power supply cord from damage.
The disconnect device is the power supply cord. Removing the power supply
cord from the mains supply isolates the product from the mains.
Disconnect the product from the mains supply if left unused for long periods
of time or during electrical storms.
Disconnect the product before cleaning, and use a dry cloth only.
Only use attachments and accessories specified by the manufacturer.
The product is for indoor use only.
2. Connecting the Kamai 7B to a TV
Warning! Before connecting or disconnecting any cable switch
off all system devices (TV, A/V Amplifier, etc) and disconnect
from the mains electrical supply. The Kamai 7B provides options
for connecting audio and video to your TV:
HDMI (recommended): best quality. Connect an HDMI cable
to the HDMI output of the Kamai 7B and to the HDMI input of
your TV.
Analogue A/V: good quality. Composite video (SD only) with
analogue audio left/right. Connect the 3.5 mm jack to the A/V
output on the Kamai 7B and connect the yellow RCA plug to the
yellow video port on your TV. Connect the red and white RCA
plugs to the red and white audio ports on your TV.
Connecting via Wi-Fi
Internal single band Wi-Fi is a feature of the Kamai 7B. Please
contact your service provider for detailed instructions about
configuring your wireless network.