Applied Force Ratemeter; Available Configuration Settings - UGO BASILE PAM Instruction Manual

UGO BASILE - I

5.4 Applied force ratemeter

If the Ratemeter option is selected in the configure menu, then, during each measurement,
PAM's display is similar to:
Acquiring Force Data
██
/\
█████
The white rectangle on the second line moves left or right of the centre marker when the
applied force is respectively below or above that required to maintain the selected target
force rate. In the above example, the applied force is below the ideal level for the specified
target force rate.
The fourth line of the display is a time progress bar indicating how much of the available
measurement time has been used.

5.5 Available Configuration Settings

The complete list of configuration options is shown below including the adjustment ranges
and default values.
Configuration flags which may be set or cleared.
 Whether each measurement is ended automatically on the force level (default) or
by pressing the foot pedal.
 Whether every measurement is stored regardless (sometimes required by GLP) or
the user may choose which measurements to store (default).
 Whether the transducer offset value is shown before each measurement or not
(default).
 Whether a warning noise sounds if a preset force is exceeded during a
measurement or not (default).
 Whether abbreviated configuration settings are shown on the Measure menu or
not (default).
 Whether the stored data includes the force waveform (default) or not.
 Whether the operator should be asked to indicate Left or Right limb or not
(default).
 Whether PAM should use Subject Numbers or not (default).
 Whether PAM should use the applied force ratemeter during tests or display
live force and time in text (default).
TALY
Page 18
38500 Instruction Manual (Rev. 1)