Cruise Control Light (All Models Except Tiger Xr And Tiger Xc); Abs (Anti-Lock Brake System) Warning Light - Triumph Tiger XR Owner's Handbook Manual

Cruise Control Light (All
Models Except Tiger XR and
Tiger XC)
The cruise control can only be
activated when
travelling at a speed between 20 to 100
mph (32 to 160 km/h) and is in 3
or higher. When activated, the cruise
control light in the tachometer will be
illuminated (see page 55).
Warning
Cruise control must only be used
where you can ride safely at a steady
speed.
Cruise control should not be used
when riding in heavy traffic, on roads
with sharp/blind bends or when they
are slippery.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when
they are slippery, may result in loss of
motorcycle control and an accident.
1. Cruise control light
the motorcycle
rd
gear
TC
TC
1
General Information
ABS (Anti-Lock Brake
System) Warning Light
When
turned to the ON position, it is normal
that the ABS warning light will flash on
and off. The light will continue to flash
is
after engine
motorcycle
exceeding 6 mph (10 km/h) when it will
go off.
Note:
• Cruise control and traction control
will not function if there is a
malfunction with the ABS system.
The warning lights for the ABS,
traction control and the MIL will be
illuminated.
The warning light should not illuminate
again until the engine is restarted
unless there is a fault, or:
• ABS is switched off - the warning
light will remain illuminated.
• ABS is set to Off Road – the
warning light will flash slowly.
If the warning light becomes illuminated
at any other time while riding it
indicates that
malfunction that requires investigation.
If the ABS is not functioning, the brake
system will continue to function as a
non-ABS braking
continue to ride for longer than is
necessary with the warning light
illuminated.
Triumph dealer as soon as possible to
the ignition switch
start-up until
first reaches a
the ABS
Warning
system.
Contact an authorised
is
the
speed
has a
Do not
25