Handling; Storage - Eaton Cutler-Hammer MP1 Series Instructions Manual

I.L.15.01.T.K
.
Page 2
be found within the enclosure, usually
attached to the inside of the door. Important
documents, such as test reports, wiring
diagrams, and appropriate instruction
leaflets, are enclosed within the envelope
and should be filed in a safe place.

2.2 Handling

As previously mentioned, transfer switch
equipment is packaged for forklift
movement. Protect the equipment from
impact at all times and do not double stack.
Once the equipment is in the installation
location and ready to be installed, packaging
material can be removed. Once the
enclosure is unbolted from the wooden
pallet, it can be hand moved to its
installation position. Two lifting lugs on the
top of the enclosure are provided as
standard on switches from 200-1200 Amps
to facilitate installation.

2.3 Storage

Although well packaged, this equipment is
not suitable for storage outdoors. The
equipment warranty will not be applicable if
there is evidence of outdoor storage. If the
equipment is to be stored indoors for any
period of time, it should be stored with its
protective packaging material in place.
Protect the equipment at all times from
excessive moisture, construction dirt,
corrosive conditions and other
contaminants. It is strongly suggested that
the package protected equipment be stored
in a climate controlled environment of -20° to
30°C with a relative humidity of 80% or less.
Do not, under any circumstances, stack
other equipment on top of a transfer switch
equipment enclosure, whether packaged or
not.
Effective June 2000