Reporting Formats; Table 5-1: Data Reporting Structure - ADT -UDACT Product Information

38
Table 5-1 shows the data reporting structure for each of the pulsed formats as well as
the Ademco Express formats. Ademco Express formats allow a typical data message
to be transmitted to the Central Station in under 5 seconds. Pulsed formats typically
require 15 to 20 seconds in comparison. Table 5-2 defines each letter code used in
Table 5-1. Table 5-3 describes the data reporting structure used for Ademco Contact
ID format. Do not select any of the pulsed or Ademco Express Formats if
identification of the specific zone or point is desired. Use Ademco Contact ID for
specific zone or point identification.
Report
Alarm
Alarm Restore
Zone Trouble
(Zone Open)
Zone Trouble Restore
System Trouble
System Trouble Restore
Low Battery
Low Battery Restore
AC Loss
AC Loss Restore
Supervisory Condition
Supervisory Condition
Restore
Test Report
Abnormal Test Report

Table 5-1: Data Reporting Structure

Refer to Table 5-2 for an explanation of each letter code in Table 5-1.
Refer to Table 6-1 for a list of compatible receivers.
Document 50934 Rev B

5.0 Reporting Formats

Format #
0,2, 4, 6, 8
3+1/4+1/Standard
4+1 Express
SSS(S) A
SSS(S) RA
SSS(S) RTZ
SSS(S) RTZ
SSS(S) TS
SSS(S) RTS
SSS(S) L
SSS(S) RL
SSS(S) P
SSS(S) RP
SSS(S) V
SSS(S) RV
SSS(S) X
SSS(S) XA
5/15/00 PN 50934:B
Format #
1,A, C
4+2/Standard
4+2 Express
SSSS AA2
SSSS RARA2
SSSS TZTZ2
SSSS RTZRTZ2
SSSS TSTS2
SSSS RTSRTS2
SSSS LL2
SSSS RLRL2
SSSS PP2
SSSS RPRP2
SSSS VV2
SSSS RVRV2
SSSS XX2
SSSS XAXA2