ADT -UDACT Product Information page 23

Loop Number (64 - 65)
For Contact ID format only. Factory default is '00'. Maximum value is '97'. Refer to
Section 5.0 for additional information.
Device/Zone Number (66 - 68)
For Contact ID format only. These entries apply to the general reports only, i.e. general
alarm, general trouble, general supervisory. Factory default is '000'. Maximum value is
'999'. Refer to Section 5.0 for additional information.
Note: For the Contact ID Format, Loop Number and Device Number do not directly
correspond to the SLC Loop or Device Number, instead, it is a convenient way to transmit
data to the Central Station. Using the default Loop Number of '00' allows the reporting of
a maximum of 999 devices or zones (001-999). To report device addresses or zones
higher than 999 (the Unimode 2020 can report up to 2,040 addresses), the Loop Number
is incremented by one to report up to an additional 1,000 device addresses or zones on
the same panel. Following is an example (using the factory defaults) of Loop Number and
Device Number settings for the ADT-UDACT on a single Unimode 2020 control panel:
Loop Number '00'
Loop Number '01'
Loop Number '02'
If the Loop Number (54-65) is programmed to 10, the devices are reported as:
Loop Number '10'
Loop Number '11'
Loop Number '12'
In applications which network multiple Fire Alarm Control Panels, the group number
may be used to help identify each facility being monitored. For example, each ADT-
UDACT can report its panel's devices by designating different Loop Numbers for each
panel. The Loop Numbers assigned to a particular panel must be sequential, but the Loop
Numbers from one panel to the next need not be sequential; i.e., the Loop Numbers
assigned for the ADT-UDACT on one Unimode 2020 might be 00, 01 or 02 while the
Loop Numbers for another FACP might be 10, 11 or 12 or any other set of unused
consecutive numbers. For additional information on the Unimode 2020/1010 control
panels, refer to Appendix D.
Programming Event Codes (69-208)
The type of reports and 'event codes' that are sent to the Central Station are in Tables 3-2
through 3-7. The selections made for the Primary Central Station Number Communication
Format (address 16) and the Secondary Central Station Number Communication Format
(address 42) automatically program addresses 69-208 with factory default selections.
Any of the event codes may be changed. Consult your Central Station prior to altering
the event codes. For the 3+1, 4+1 and 4+1 Express Formats, entering an event code of '0'
will cause the communicator to NOT transmit the report. Enter two zeroes for 4+2 and
4+2 Express Formats. For Ademco Contact ID format enter three zeroes. Transmission of
reports to either or both Central Station phone numbers may be disabled.
Note the special 'System Abnormal Test Report' event code. This report was added per
new UL DACT requirements. This report is generated in place of the normal test report
when an alarm and/or trouble condition exists at the time the test report is due to be sent.
Document 50934
reports points/zones 00 001 to 00 999
reports points/zones 01 000 to 01,999
reports points/zones 02 000 to 02,040
reports points/zones 10 001 to 10 999
reports points/zones 11 000 to 11,999
reports points/zones 12 000 to 12,040
Rev B 5/15/00 PN 50934:B
23