Programming Mode - Valken Code Manual

CHANGING THE PARAMETERS
User can change the setting by entering the programming mode.

Programming Mode

Enter programming mode by holding down trigger and then turning the marker on. Cycle through different setting by pressing the
trigger once. Color Setting:
• Green .................. Firing Modes
• Purple ................ Max Rate of Fire
• Yellow ................. Fine timing for max rate of fi re
• Blue .................... Debounce
• Red ..................... Dwell
• White .................. Ramp Start
• Aqua .................. Ramp Percent
Once you are in the desired setting, press and hold the trigger again for 2sec and the LED will start blinking. The last accessed setting
is remembered so you don't have to keep cycling through settings when you want to test different dwell settings, for instance. When
the blink stopped, you can enter the new numbers by pressing the trigger.
PROGRAMMING MODE
valken.com valken.com