Valken Code Manual
  1. Manuals
  2. Brands
  3. Valken Manuals
  4. Paintball equipment
  5. Code
  6. Manual

Valken Code Manual

.68 caliber electronic marker
Hide thumbs Also See for Code:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

QUICK SETUP GUIDE
.68 CALIBER ELECTRONIC MARKER
v a l k e n . c o m
valken.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Code and is the answer not in the manual?

Questions and answers

Related Manuals for Valken Code

Summary of Contents for Valken Code

  • Page 1 QUICK SETUP GUIDE .68 CALIBER ELECTRONIC MARKER v a l k e n . c o m valken.com...

  • Page 2: Specifications

    Persons under 18 years of age must have adult supervision. READ OWNERS MANUAL BEFORE USING. Rules of Safe Marker Handling. 1. Treat every marker as if it were loaded. 2. Never look down the barrel of a paintball marker. CODE SPECIFICATIONS: 3. Keep your finger off the trigger until ready to shoot. Caliber: 0.68 4.
  • Page 3 1/16” hex key to remove the eye cover. If any malfunction should occur the software automatically overrides the eye function and The CODE has a standard ASA to accept a screw in air tank. First, make sure that the On/OFF is in OFF position (lever pointing to the reduces the rate of fire.

  • Page 4: Velocity Adjustment

    Adjusting the velocity Trigger adjustment The CODE has an adjustable regulator in the handle frame that controls the pressure in the marker thereby controlling the velocity. The trigger has adjustments for microswitch activation point and pre travel. The best way to adjust the velocity is to turn the adjusting screw clockwise using a 3/32” hex key. This will be the minimum velocity.

  • Page 5: Programming Mode

    When the blink stopped, you can enter the new numbers by pressing the trigger. Unlimited 10 (Default) valken.com valken.com valken.com valken.com...
  • Page 6 Blinks Increment BPS Blinks Increment BPS Blinks Blinks Blinks Blinks Blinks 0.0 (Default) 15 (Default) Debounce(Blue) Ramp Start(White) Use by PSP and normal ramping Modes. Blinks Blinks Blinks Blinks Blinks Blinks Blinks Blinks 5 (Default) 10 (Default) 20 valken.com valken.com...

  • Page 7: Maintenance

    Removing the ball detents for cleaning The CODE uses two rubbery ball detents to prevent the double feeding of paintballs. They are located near the front of the receiver. To remove, insert a 1/16” hex key into the access hole in the eye cover. Make sure that the hex key is fully engaged in the screw otherwise you may strip the hex in the screw.
  • Page 8 CODE SCHEMATICS CODE SCHEMATICS Item Description Item Description Item Description Item Description Main Body Back Cap lock spring BHCS 6-32 X .250 ASA Plug Feedneck Body Back Cap Lock pin Regulator Cover Fliter Cap Feedneck lever Set Screw M2 0.5 X 0.45...

  • Page 9: Limited Warranty

    To activate your warranty, fill out the warranty card and mail it along with a copy of the original purchase receipt. In the event that a part is defective Valken Sports will send out a replacement part free of charge. Wearable items such as o-rings, seals, screws, ball detents and the like are not covered under this warranty.

Table of Contents