Valken Code Manual page 4

QUICK SETUP GUIDE
Attaching the barrel
The barrel simply threads on. The barrel threads are autococker type.
Attaching the loader
Open the clamp lever and place the loader into the feedneck. Adjust the tightness of the clamp with a 5/32" hex key. Close the clamp
lever.
Battery replacement
Remove grip cover from foregrip. Press the button on the lower front of the foregrip. Pull the 9V battery out and dislodge it from the
battery cap. Replace with a fresh 9V battery. We recommend the use of a high quality alkaline battery.
Connecting the air source
The CODE has a standard ASA to accept a screw in air tank. First, make sure that the On/OFF is in OFF position (lever pointing to the
front). Carefully screw in the air tank until it stops. Flipping the lever backward will allow air to fl ow into the marker from the tank.
To remove the tank, fl ip the lever forward. This will release all the air in ASA and make it easier to remove the tank. We recommend the
use of compressed air or nitrogen air tank with a maximum output pressure of 800 PSI.
valken.com