Valken Code Manual page 5

QUICK SETUP GUIDE
Turning the marker ON
Press power button. Eyes on is blue/blinking blue for blocked/
unblocked eyes. Blinking yellow for eye malfunction (if the eyes
don't see the bolt return like if you block the eyes continually
with your fi nger). Eye malfunction reduces rate of fi re to prevent
additional chopping.
Turning the marker OFF
Hold power button for 2 seconds or until the LED goes off to turn
off the marker.
Intelligent break beam ball sensor system
The CODE has a break beam sensor system. The eyes can be cleaned by simply removing the bolt and using a squeegee, or using
a 1/16" hex key to remove the eye cover. If any malfunction should occur the software automatically overrides the eye function and
reduces the rate of fi re. When the marker fi rst powers up, the eyes are on by default. To disable the sensor system, press the on/off
button for 1 sec until the LED is blinking red. To enable the eyes again, simply press the on/off button again for 1sec until the LED is
blinking blue.
valken.com