Programming Mode - Valken Code Manual

PROGRAMMING MODE

CHANGING THE PARAMETERS
User can change the setting by entering the programming mode.
Programming Mode
Enter programming mode by holding down trigger and then turning the marker on. Cycle through different setting by pressing the
trigger once. Color Setting:
• Green .................. Firing Modes
• Purple ................ Max Rate of Fire
• Yellow ................. Fine timing for max rate of fire
• Blue .................... Debounce
• Red ..................... Dwell
• White .................. Ramp Start
• Aqua .................. Ramp Percent
Once you are in the desired setting, press and hold the trigger again for 2sec and the LED will start blinking. The last accessed setting
is remembered so you don't have to keep cycling through settings when you want to test different dwell settings, for instance. When
the blink stopped, you can enter the new numbers by pressing the trigger.
valken.com valken.com
PROGRAMMING MODE
Firing Modes(Green)
The firing mode can be changed after entering the programming mode.
# Blinks in Fire Mode
1 Unlimited Semi auto
2 Adjustable Semi auto
3 PSP ramping
4 PSP Burst
5 NXL Full Auto
6 Millennium Ramping
7 Normal Ramping
8 Auto Response
9 Burst
10 Full Auto
Max Rate of Fire(Purple)
Blinks BPS Blinks BPS Blinks BPS
5 5 11 11 17 17
6 6 12 1 18 18
7 7 13 13 19 19
8 8 14 14 20 20
9 9 15 15 21 21
10 10 (Default) 16 16 22 22
valken.com valken.com
Blinks BPS Blinks BPS
23 23 29 29
24 24 30 30
25 25 31 Unlimited
26 26
27 27
28 28