Setup And Operation; Gauge Start Up And Operation; Gauge Status Leds - Instrutech Busy Bee PCM301 User Manual

Instruction Manual

4 Setup and Operation

4.1 Gauge start up and operation

Read this user manual in its entirety before operating the instrument.
The signal output is available when power is applied to the gauge. Allow for a stabilizing time of approx. 10 min.
Once the gauge has been switched on, it can remain in operation continuously regardless of the pressure.
Connect power to the PCM301 using the designated pins 3 and 4 of the 9-pin D-sub connector. Alternatively,
you can power the device by connecting InstruTech's PS401-A power supply to the gauge.

4.2 Gauge Status LEDs

LED
<ST>
lit solid or blinking red
<SP1>
<SP2>
InstruTech
DIA
SP2
Light-emitting diodes (LEDs)
State Condition
off no supply voltage
lit green measurement mode
error
lit green SP1 Relay closed
off SP1 Relay open
lit green SP2 Relay closed
off SP2 Relay open
ST
Status
SP1
ADJ
PCM301 Busy Bee
Page 13