Table of Contents
Advertisement
Instruction Manual
mounting orientation
analog output
output impedance
load impedance
error signal
response time
input power
(1)
fuse required
supply voltage ripple
setpoint relays
(2)
setpoint relay hysteresis
setpoint relay range (N
)
2
setpoint switching time
connector
diagnostics port
CE compliance
environmental
WARNING!
(1)
The gauge may only be connected to power supplies, instruments, or control devices that conform to the
requirements of a grounded protective extra-low voltage (SELV) and limited power source (LPS), Class 2. The connection to the gauge has
to be fused.
(2) The hysteresis and the switching characteristics can be programmed via the diagnostic port
Dimensions
1.3
InstruTech
any
log-linear 0 to 8 Vdc, 1 V/decade
2 × 4.7 , short-circuit proof
≥10 k, short-circuit proof
analog output switches to 0 V
< 30 ms
15 to 30 Vdc, ≤ 2.5 W protected against power reversal
1 AT
<1 p-p
2 Solid State, normally open, potential free, <30 V (ac) / (dc), ≤0.3 A resistive
10% of threshold
3.8 x 10
-5
to 1,125 Torr
<30 msec
9-pin D-sub male
3-pin, 2.5 mm Jack connector
EMC (EN61000-6-2, EN61000-6-3, EN61010)
RoHS compliant
in. (mm)
.
Fitting
1/8 in. NPT
NW16KF
NW25KF
1 1/3 in. Mini-CF
1/4 in. Cajon 4VCR
1/2 in. Cajon 8VCR
NW16KF w. Long Tube
1 1/3 in. Mini-CF w. Long Tube
PCM301 Busy Bee
dimension A
1.41 in. (36 mm)
0.57 in. (14.5 mm)
0.85 in. (21.5 mm)
1.22 in. (30.9 mm)
1.68 in. (42.7 mm)
1.82 in. (46.3 mm)
5.15 in. (130.8 mm)
5.13 in. (130.2 mm)
Page 4
Advertisement
Table of Contents
