Hardi 5500 Instruction Book page 26

HARDI CONTROLLER 5500
Menu [3.2.3 Tank method] Menu [3.2.3 Tank method] Menu [3.2.3 Tank method] Menu [3.2.3 Tank method] Menu [3.2.3 Tank method]
3.2.3
FLOW CALIBRATION
Tank method
During practical flow calibration the tank is partly emptied through the
nozzles. Whilst emptying, the display calculates the quantity emptied on the
basis of the actual calibration value (PPU). The quantity displayed is com-
pared with the quantity actually dosed.
This can be according to the tank contents level indicator or by weight
difference before and after. The quantity displayed is corrected to read the
quantity actually dosed.
Method Method
Method Method Method
1. Place the tank on level ground and fill it up with water until the level
reaches a unique mark on the tank contents level indicator, e.g. 1000
litres.
2. Open all boom sections.
3. Go to menu [3.2.3 Tank method] and switch the main ON/OFF to ON.
4. Engage the P.T.O.
3.2.3
TANK METHOD
Sprayed
The display unit will then begin to count the
volume being emptied through the nozzles.
5. When for example, 600 litres have been emptied out, as shown by the
tank contents level indicator, disengage the P.T.O. and switch the main
ON/OFF to OFF.
6. Press .
7. Correct the volume shown on the display with the navigation keys to read
the volume shown on the tank contents level indicator.
8. Press to confirm.
26
XXXX L