Table of Contents
Advertisement
CAUTION: Do not mix 2250W, 2400W High Efficiency,
BL7000 2400W Platinum, or -48vDC power supplies in
one enclosure. Install only one type of power supply in a
single enclosure.
If your BladeSystem c7000 Enclosure is equipped with a
three-phase power configuration, you need six power supplies.
To install a power supply:
1.
To gain access to all power supply bays, slide the
BladeSystem Insight Display to the right or left as needed.
2.
Remove the power supply blank.
3.
Insert the power supply into the enclosure, and then close the
power supply bracket.
NOTE: This document discusses installation of AC
power supplies only. For information on configuring DC
power supplies or Carrier Grade Solutions, see the
documentation that came with your power supply.
4.
Add any ordered options to each server blade:
o
Additional processor
o
Additional memory
o
Mezzanine option cards
5.
(Optional) If you are installing a full-height device, remove the
half-height device bay shelf. If you are installing a half-height
device, omit this step.
6.
Remove the connector covers.
7.
Install the server or storage blades.
8.
Install device bay blanks into any unused device bays.
If the empty bays are configured for a full-height device, join
two device bay blanks to create a full-height blank.
Installing the rear components
5
Advertisement
Table of Contents
