EUROM Polar 70 Instruction Manual page 70

Dehumidifying operation
Press on the MODE button to select the DRY
1.
function.
2. Press on TEMP
temperature.
3. Press on the ON/OFF button to start.
Remark:
In the DRY function, you cannot select the fan
speed; this occurs automatically.
Timer operation
Press the Timer ON button to set the automatic
switch ON time; press the Timer OFF button to set
the automatic switch OFF time.
1. Setting the time for automatic switch ON.
a. Press the TIMER ON button. The remote
control shows TIMER ON, the signal 'h' is
shown on the LCD display. Now it is ready for
resetting the Auto-on time to start the
operation.
b. Press again on the TIMER ON button to set the
desired Auto-on time. Every time you press
the button, the time increases in steps of 30
minutes until 10 hours and henceforth in steps
of 1 hour to 24 hours.
c. After the TIMER ON is set, it takes half a
second before the remote control transmits
the signal to the air conditioner. After
approximately 2 seconds, the 'h' signal
disappears and the set temperature appears
again on the LCD display.
The timer function control light on the airco
goes on.
2. Setting the time for automatic switch OFF.
a. Press the TIMER OFF button. The remote control shows TIMER OF, the signal
'h' is shown on the LCD display. Now it is ready for resetting the Auto-off
time to start the operation.
b. Press again on the TIMER OFF button to set the desired Auto-off time. Every
time you press the button, the time increases in steps of 30 minutes until 10
hours and henceforth in steps of 1 hour to 24 hours.
or to set the desired
70