EUROM Polar 70 Instruction Manual page 64

in a hanging window
1. Cut the adhesive window sealing-strip to size and affix it to the window casing
(Fig. 1).
2. Place the window frame girder in the opening (Fig. 2).
3. Cut the non-adhesive window sealing-strip to size for the width and/or height of
the window. Place the strip between the window and the window casing (Fig. 3)
to prevent draught and insects from coming inside.
4. If required, you can install the safety support (Fig. 4).
5. Insert the connecting piece of the window frame girder into the hole of the
window frame girder (Fig. 5).
Installation 2
1. Drill a ø125 mm in the wall to
accommodate the wall sealing with cap.
The centre of the hole must be at least
30 cm and maximum 120 cm above
the ground.
2. Firmly affix the wall sealing with cap to
the wall using the four plugs and
screws included in the delivery (see the
figure).
3. Connect the drain hose including the
connecting piece of the wall drain with
the wall sealing with cap.
If you do NOT use the device, cover the hole with the flap of the wall
sealing!
in a sliding window
64