Mounting Procedure; Assembly Diagram; Installation - Hyundai KR 815 PLLU Instruction Manual

MOUNTING PROCEDURE

Make sure that the plug is not inserted when assembling the device!
• Remove all objects from the cupboard and anything which is fragile in the adjacent cup-
boards.
• For the installation the cupboard must fulfill the following conditions: Thickness of the cup-
board floor between 16 mm and 20 mm.
• The wall mounting of the cupboard must be stable and anchored firmly in the wall with at least
2 screws.
• Important! Do not install the device above a cooker!
• When installing the device it must be ensured that there is a power socket within reach.
• The mains socket must be within easy reach, so that the plug can be quickly removed in an
emergency.
• Important! Do not connect the device to the mains power supply until after installation!
• The device cannot be installed under cupboards under which there is a lighting strip.
• For mounting, you may need the following supplies: A drill with 6 mm drill bit, pilot drill or nail,
Allen key, tape measure, adhesive tape, scissors, safety goggles.
MOUNTING PROCEDURE
Supplied mounting accessories
4 x Screws
4 x Spacers
1 x Drilling template
CAUTION!
• Please adhere to the dimensions stated in
the installation instructions.
• You should use only the installation accessories
supplied.
• Use a wrench and not an electric screwdriver.

INSTALLATION

• Tape the template firmly down to the shelf with
adhesive tape. With the help of a gimlet or nail pierce the crosses at the attachment points
and use it to mark the holes.
• Remove the template and drill the holes into the wall cupboard.
• Insert the spacer into the holes provided on the device.
• Countersink the screws into the holes in the cupboard.
• Using the 4 screws and the spacers, attach the kitchen radio to the bottom of the cupboard.
• Tighten the screws hand-tight with an Allen key.
NOTE:
Sufficient ventilation is only guaranteed with a spacer.
STAND ALONE USE / TABLE TOP USE
Use the 4pcs rubber feet provided and stick 1pc each on the 4 corners of the bottom of the unit.
In this case, the unit can be use as an independent sound system on the table without
under-cabinet.

ASSEMBLY DIAGRAM

EN - 24