Advertisement
4. Preparations for use
1. Check that the right nosepiece and mandrel are fitted for the Pop Nut.
Adjust the protruding length of the mandrel.
(Refer to page 15 for details of replacement and adjustment).
2. The coupling diameter of the compressed air supply coupling is Rc 1/4.
Connect a joint or coupler of connection diameter R1/4 to supply compressed air.
(The coupler and joint are not provided.)
3. An air filter, regulator and lubricator should be fitted in the air line between the
compressor and the tool, within 3m of the tool. Adjust the supply pressure and
the drip volume of the lubricator oil.
-Compressed air pressure: 0.5~0.6 MPa.
-Oil drip volume from the lubricator: 1~2 drops/ 20 nuts fastened
Regulator
Air filter
Compressor
WARNING!
According to the actual operating temperature, use an air hose able to withstand
0.7MPa at the maximum ordinary operating pressure. Also make sure the hose
material is suitable for the operating environment (e.g. oil proof, wear and abrasion
resistance etc.).
*For details, refer to a hose manufacturer's catalog.
Lubricator
Hose
Coupler（Socket）
I.D.6.5mm Min
.
3m Max
.
Coupler (Plug)
Thread size R 1/4
Not attached
7
PNT800
Figure 4-1
Advertisement
