Advertisement
(6) Adjust the total length of the assembly to 66±0.1mm, and tighten the
lock screw on the control knob hard. (Figure 7-12)
（Figure 7-12）
(7) Push the assembly into the body of the tool, and reverse the above
procedure to reassemble all parts.
(8) Loosen the lock screw on the control nut and turn the control knob to the
right until the control nut stops at the end of its movement, and then
tighten the lock screw. (Figure 7-13)
(9) Set a Pop Nut without workpiece, and check the stroke. If stroke of
1.3mm or less is obtained, it is normal. (Figure 7-14)
Lock screw
Note: When stroke is over (1.3mm or more), check the assembly length
(proper length: 66±0.1), and readjust.
When other troubles are caused, do appropriate treatment refer to the "8.
Troubleshooting" (p.21).
Figure 7-13
17
PNT800
Stroke
Figure 7-14
Advertisement
