Assembling The Centrifugal Clutch; Dismantling The Oil Pump And Screen; Assembling The Oil Pump And Screen - Husqvarna 543 XP Workshop Manual

7.11 Assembling the centrifugal clutch

1
Use special tool 513 63 65-01 and assemble the
clutch according to figure 20.
2
Screw in the clutch (anti-clockwise) until it stops.
Then tighten the clutch using tool 513 63 60-01
and a suitable socket wrench or combination span-
ner. Tightening torque of 29,4-34,4 Nm.
3
Remove the piston stop and fit the spark plug us-
ing a tightening torque of 8,8-12,7 Nm. Attach the
spark plug hat.
Then fit the:
• cylinder cover
• guide bar
• saw chain
• clutch cover
7.12 Dismantling the oil pump and
screen
1
Empty and clean the saw chain oil tank.
Dismantle the centrifugal clutch as outlined in
"Dismantling the centrifugal clutch".
2
Remove the clutch.
3
Remove the chain guide plate and the oil pump
cover. See figure 22.
4
Remove the oil pump from the crankcase together
with the oil pressure hose. See figure 22.
Cleaning and inspection
• Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of
other defects. Always use original spare parts.
• Lubricate all moving parts with saw chain oil.
Fig 20
Fig 21
Fig 22
Repair Instructions
31
English -