Connecting To A Tv - Samsung VP-DX10 User Manual

connection
You can view the recorded movie and photo images on a large screen by connecting the DVD camcorder to a TV.

CONNECTING TO A TV

• To play back your recordings, the television must be PAL compatible.
page105
• We recommend that you use the AC power adaptor as the power source for the
DVD camcorder.
Use the provided AV cable to connect the DVD camcorder to a TV as follows:
1. Connect the end of the AV cable with the single plug to the AV jack of the
camcorder.
2. Connect the other end with video (yellow) and left(white)/ right(red) audio cables
to the TV.
• For more information about the connection, refer to your TV's user manual.
• Before connecting, make sure that the volume on TV is turned down: forgetting this
may cause feedback from the TV speakers.
• Carefully connect the input and output cables to the corresponding connections on
the device the DVD camcorder is being used with.
Viewing on TV screen
1. Turn on the TV and set the input selector to the Input connection the DVD camcorder is connected to.
- This is often referred to as "line". Refer to the TV instruction manual for how to switch the TV input.
2. Turn the DVD camcorder on.
- Slide the POWER switch downward and press the Play mode (
- Open the LCD screen and set the appropriate storage media. page 31
- The image from the DVD camcorder will appear on the TV screen.
3. Perform playback.
- You can perform playback, recording or make settings in the menu while viewing on your TV screen.
• Adjust the sound volume on TV.
• The remote control is useful when operating the DVD camcorder while viewing an image on TV screen.
• If only a mono audio input is available on the connected device (TV, etc.), use the audio cable with the white jack (Audio L).
• When a copy-protected movie is played back, no image will appear on TV screen.
• When "TV Display" is set to off, OSD(On-Screen-Display) does not appear on the TV screen.
• Information that the DVD camcorder is recording will appear on the TV screen: Press the Display (
switch the display status. page 26
• Howling may occur when the DVD camcorder is too close to the other devices or the volume is high. Keep the DVD camcorder
away from the other connected devices.
50_ English
DVD camcorder
Signal fl ow
AV cable
) button to set the Play mode. page 21
) / iCHECK button to
TV