Standing On A Horizontal Surface - GLP Fusion EXO Wash 30 User Manual

German Light Products®
1. Attach suitable clamps to the Omega brackets.
2. Line up the fasteners of the Omega bracket with the holes "A" in the
base of the EXO Wash 30 as shown in Figure 4. The brackets may be installed
either way round so the cabling is in line with the bar or at right angles to it.
3. Lock the Omega brackets onto the EXO Wash 30 by turning the fasteners
through 90 degrees.
4. Attach the clamp to the truss or structure. Ensure that the head and yoke
of the fixture will not collide with any fixed objects as the fixture moves. Ensure
that the fixture has sufficient clearance to any adjacent surfaces or objects.
5. Secure the fixture with a safety cable through slots "B" as described in the
previous section.

Standing on a horizontal surface

To install an EXO Wash 30 fixture on a horizontal surface:
1. Check that the surface is secure and can safely hold the weight of the
fixture plus all hardware and cables.
2. Stand the fixture firmly on the rubber feet fitted to the base of the unit.
Ensure that the head and yoke of the fixture will not collide with any fixed
objects as the fixture moves. Ensure that the fixture has sufficient clearance to
any adjacent surfaces or objects.
EXO Wash 30 User Manual Rev. B
Installation
Figure 4. Omega bracket fasteners
17