Table of Contents
Advertisement
www.glp.de
To secure an EXO Wash 30 fixture with a safety cable:
1.
Loop a safety cable around a secure anchoring point such as a truss
beam or fixed structure so that it will catch the fixture if a rigging clamp fails.
Take up as much slack as possible in the safety cable (by looping it more than
once around the bar, for example).
2.
See Figure 3 and Figure 4. Fasten the safety cable through the slot "B" on
the underside of the fixture base. Check that the fixture is now secured.
Installing on a rigging truss or similar structure
You can suspend an EXO Wash 30 fixture from a rigging truss or pipe using suitable
clamps attached to the Omega Brackets supplied with the EXO Wash 30.
If you are going to install the fixture hanging vertically downwards from a horizontal
rigging truss or pipe, you can fasten it to the truss using G-clamps. If you are going to
install the fixture in any other orientation, you must use half-coupler clamps that
completely surround the truss chord or pipe.
16
Installation
Figure 3. Safety cable attachment
EXO Wash User Manual Rev. B
Advertisement
Table of Contents
