Table of Contents
Advertisement
3.3.3 Angle of the footplate
To adjust the angle of the footplate:
1. Remove the screws of the two adjustment plates located on both sides.
2. Remove also the screws on the bottom side of the two adjustment plates.
3. Switch the left adjustment plate to the right side and do the opposite for the right
adjustment plate.
4. Retighten all screws properly.
3.4
Adjusting of the splash guards
L L L L
CAUTION:
Risk of clamping – Do not place fingers, buckles and clothes between
the splash guards and rear wheels.
2
1
3.5
Adjust the brakes
L L L L
WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
1
The splash guards of the wheelchair can be adjusted
in 2 different positions.
Height of splash guard
120 mm
155 mm
Table 2: Height of splash guard
1.
Grasp the splash guard on the top.
2.
Pull the splash guard upwards.
3.
Remove the splash guard.
A
4.
Mount the splash guard again, so the plastic
pins ➁ clicks in the desired holes
B
the splash guard.
C
Adjust the brakes according following rules:
1. Disconnect the brakes by pulling lever
backwards.
2. Loosen the bolts
can move.
3. Move the brake mechanism
position.
2
4. Retighten the bolts
5. Check working of the brakes.
3
6. If necessary repeat the above steps until the
brakes are adjusted well.
Page 13
2011-07
Holes
A and B
B and C
grooves of
so the brake mechanism
to the desired
.
925
Advertisement
Table of Contents
