Handling And Soldering; Packaging, Shipping, Storage, And Moisture Preconditioning; Handling; Soldering - Ublox NORA-B1 Series System Integration Manual

5

Handling and soldering

☞
No natural rubbers, hygroscopic materials or materials containing asbestos are employed.

5.1 Packaging, shipping, storage, and moisture preconditioning

For information pertaining to reels, tapes or trays, moisture sensitivity levels (MSL), shipment and
storage, as well as drying for preconditioning, refer to the NORA-B1 series data sheet [1] and u-blox
package information guide [2].

5.2 Handling

NORA-B1 series modules are Electrostatic Discharge (ESD) sensitive devices and require special
precautions during handling. Care must be exercised when handling patch antennas, due to the risk
of electrostatic charges. In addition to standard ESD safety practices, the following measures should
be considered whenever handling the receiver:
•
Unless there is a galvanic coupling between
the local GND (workbench ground) and the
PCB GND, then the first point of contact
when handling the PCB must always be
between the local GND and PCB GND.
•
Before mounting
connect the ground of the device
•
When handling the RF pin, do not come in to
contact with any charged capacitors. Also
be careful when contacting materials that
can develop charges, for example, the patch
antenna (~10 pF), coaxial cable (~50-80
pF/m), soldering iron, and so on.
•
To prevent electrostatic discharge through
the RF input, do not touch any exposed
antenna area. If there is any risk that such
an exposed antenna area is touched in a
non-ESD protected work area, implement
proper ESD protection measures in the
design.
•
When soldering RF connectors and patch
antennas to the receiver's RF pin, make
sure to use an ESD safe soldering iron (tip).

5.3 Soldering

5.3.1

Reflow soldering process

NORA-B1 series modules are surface mounted and supplied on a FR4-type PCB with
gold-plated connection pads. The modules are manufactured in a lead-free process using lead-free
soldering paste. The bow and twist of the PCB is maximum 0.75% according to IPC-A-610E. The
thickness of solder resist between the host PCB top side and the bottom side of the NORA-B1 series
module must be considered for the soldering process.
UBX-20027617 - R02
C1-Public
an antenna patch,
Handling and soldering
NORA-B1 series - System integration manual
Page 35 of 58