Liability - AUTOTERM COMFORT CONTROL User Manual

-
The heater is not designed for installation and use on any type of ADR transportation
vehicle.
-
When refuelling heater must be shutdown. Note: shutdown process can take up to 10
minutes.
-
The vehicle where the heater is installed must be equipped with a fire extinguisher.
-
Do not cover the heater with clothing, pieces of fabric and so on, and do not place such
objects in front of the air intake pipe or inlet and output of the heated air.
-
Do not use or install the heater in places, where flammable vapours or gases or large
amounts of dust may form and accumulate.
-
Do not use or install the heater in places, where flammable and/or explosive items or
substances are stored.
-
Avoid contact of any flammable objects with the heater's exhaust pipe.
-
Do not connect/disconnect any wiring of the heater while it is connected to the power
supply or operating.
-
Do not connect the heater to the power circuit of the vessel, when the engine is
operating and there is no battery.
-
The heater can be switched on again 15-20 seconds after disabling indications on the
control panel, which means that the heater has shut down.
-
In case of faults in the operation of the heater, contact specialized repair organizations
authorized by AUTOTERM.
Manufacturer is not liable for any damage as a result of installation and repairs by
uncertified personnel and/or use of third-party parts and accessories without the
approval of manufacturer.
In case of any problems, we strongly recommend to contact certified service centres. Contact
information and location of certified service centres can be found at our website
www.autoterm.com.
Risk of fire and explosion
Risk of damage due electrical nature
Personnel certified by AUTOTERM is needed

LIABILITY

4