Led; Reset - AUTOTERM COMFORT CONTROL User Manual

o FAN
To activate the "Fan" function, after enabling it, heater must be disconnected and
reconnected from the power supply.
Additional relay set is required for this option to work. Contact Your local dealer.
o EXTERNAL START – enable/disable external start. For this function to work grey
o COOLANT PUMP
▪ WAIT MODE
▪ WITH ENGINE
o PUMP TYPE
▪ BOSCH
▪ ADVERS
4.5.

LED

•
Turn on or off the LED indicators.
4.6.

RESET

•
Reset the control panel to factory settings.
– set and enable/disable activation of the interior fan. Set
coolant temperature at which interior fan of the vehicle will
activate. Temperature can be set in rage a of 30°C to 60°C.
Default value is 40°C.
and black wires of the control unit must be connected to the
alarm system of the vehicle. See installation manual of the
heater.
– enable/disable operation modes of the coolant pump:
– When enabled, coolant pump will continue to operate after
the heater in pre-heating mode has reached the set
temperature and stops the heating process. If disabled,
heater coolant pump will stop the circulation when heater
stops the heating.
– When enabled, coolant pump starts when the engine of the
vehicle starts. This option improves the circulation of the
coolant.
– select the type of the coolant pump depending on the
coolant pump in use:
– Pump operates using PWM signal.
– Pump operates using DC.
15