Reely ROAD 23 72 40 Operating Instructions Manual page 52

Flashing frequency of the red LED (currently set value for hand braking function):
1x short = 0%
2x short = 5%
3x short = 10%
4x short = 15%
• Briefly press the set-up button at the speed controller to select the next value. Check the flash signal of the red LED
Once the desired value is reached (for 40% the red LED will flash 1 x long and 3 x short), switch off the speed
controller unit. This concludes the programming. The value is saved.
If you wish to adjust other settings (e.g. low-voltage protection), proceed as described above.
Release the set-up button exactly when the green LED flashes for the corresponding function to be adjusted
(or the corresponding beep tone is heard, depending on the motor); an exact description of the individual
functions is given below.
Then press the set-up button shortly as often as required until the red LED flashes corresponding to the
desired setting value.
If the speed controller unit is switched off, the current setting and/or value will be saved.
The following functions are available:
# Green LED blinks... Function
(+ beep)
1 1x short Drive function
2 2x short Handbrake
3 3x short Undervoltage protection off
4 4x short Start mode
5 1x long Maximum brake power
6 1x long, 1x short Max. speed for driving
backwards
7 1x long, 2x short Minimum brake power
8 1x long, 3x short Neutral range
9 1x long, 4x short Timing
10 2x long Motor type
11 2x long, 1x short Excess temp. protection +95°C
The settings/values with the grey background are the factory settings made by the manufacturer. For
newer speed controller versions, the manufacturer may have stored other basic settings.
Usually, the speed controller is delivered programmed suitably for the vehicle. If you want to program it on
your own, always check all settings or adjust them to your preferences.
Observe the description of the individual speed controller functions on the following pages.
1x long= 20%
1x long, 1x short = 25%
1x long, 2x short = 30%
1x long, 3x short = 40%
1x short
Forward/brake Forward/brake/
0
Soft
25%
25%
= handbrake
6%
0.00
Brushless
Red LED blinks...
2x short 3x short 4x short
backward
5% 10% 15%
2.6V/cell 2.8V/cell 3.0V/cell
Normal Fast Very fast
50% 75% 100%
50% 75% 100%
0% 20% 40%
9% 12%
3.75 7.50 11.25
Off
1x long 1x long, 1x long,
1x short 2x short
20% 25% 30%
3.2V/cell 3.4V/cell
15.00 18.75 22.50
1x long,
3x short
40%
26.25
51