Appliance Break-In; Heat Management - Hearth & Home LCOR-DV36IN Owner's Manual

G. Appliance Break-In
Follow the initial break-in procedure below to cure the
materials used to manufacture the fireplace and the
finishing materials around it.
• The fireplace should be run three to four hours
continuously on high.
• Turn the fireplace off and allow it to cool completely.
• Remove fixed glass assembly. See Section 4.B.
• Clean fixed glass assembly. See Section 4.
• Replace the fixed glass assembly and run continuously
on high an additional 12 hours.
Note: The IntelliFire Touch
that automatically shuts down the fireplace after 9 hours
of continuous operation without receiving a command from
the remote control. If this occurs, restart the appliance.
NOTICE! Open windows for air circulation during fire-
place break-in.
• Some people may be sensitive to smoke and odors.
• Smoke detectors may activate.
H. Heat Management
Heat Output
The flame on this model may be adjusted only if an
optional RC-400 remote control is installed. Contact your
dealer to order the RC-400.
If an optional fan is installed, the fan speed is controlled by
adjusting the speed control knob or using the command
on the optional remote control, if installed. If the rheostat
included in the optional fan kit is installed, turn the knob
clockwise to increase the fan speed and counterclockwise
to decrease the fan speed.
12
Hearth & Home Technologies • LCOR-DV36IN, RCOR-DV36IN Owner's Manual • 2486-981 Rev. F • 10/20
system has a safety feature
®