Non-Combustible Material - Fisher & Paykel GC36 Installation Instructions Manual

Clearances
a
36" = Minimum horizontal distance between overhead cabinets installed on either side of
this appliance.
b
30" = Minimum clearance from combustible surface centered above the cooktop.
c
13" = Maximum overall depth of overhead cabinetry.
d
18" = Minimum clearance from countertop to overhead cabinetry.
e
1
4" (GC36) or 1 / " (GC912 & GC912M) = Minimum clearance from cooktop to the left side wall.
2
f
1" = Minimum clearance from cooktop to the right side wall.
g
1 1
1 / " (GC36) or 1 /
2
h
1 1
2 / " (GC36) or 1 /
2
front edge of appliance. Where this reduces the distance between the back edge of the
appliance and the adjacent wall to less than the minimum of 1
GC912M), this wall must be of non combustible material (see note below).
i
3 5
2 / " (GC36) or 3 /
8
combustible surface.
j
30" = Maximum distance to nearest grounded power outlet from the center of the cooktop.
The power cord must not touch any hot metal surfaces.

Non-combustible material

Recommended non combustible materials are:
with not less than No. 28 MSG sheet steel, 0.015" (0.4mm) stainless steel, 0.024" (0.6mm)
aluminium or 0.020" (0.5mm) copper.
b
g
h
e
" (GC912 & GC912M) = Minimum clearance from cooktop to the rear wall.
4
" (GC912 & GC912M) = Minimum distance from front edge of counter to
4
" (GC912 & GC912M) = Minimum clearance below countertop to any
16
a
c
d
i
j
f
1
/
1
/ "" (6mm) flame retardant millboard covered
4
1
" (GC36) or 1 / " (GC912 &
2 4
US
5