Ethernet Power Injector (Optional) - Watchguard AP125 Hardware Manual

Ethernet Power Injector (Optional)

You can power your WatchGuard AP with an optional Ethernet Power Injector. This PoE+ capable device
enables you to power the WatchGuard AP through an existing Ethernet connection. With this feature, you
do not have to position your WatchGuard AP near a power outlet.
This device complies with IEEE 802.3at/af PoE specifications. Do not use any PoE
adapters that are not IEEE 802.3at/af compliant as they may damage your device.
To connect an Ethernet Power Injector to the WatchGuard AP:
1. Plug the Ethernet Power Injector into an AC power source.
2. Connect an Ethernet cable from your network backbone (for example, a router, switch, or hub) to the
LAN connector on the Ethernet Power Injector.
3. Connect an Ethernet cable from the LAN2 (PoE) Ethernet interface on the AP to the PoE connector on
the Ethernet Power Injector.
The table below provides the specifications for the Ethernet PoE injector.
Ethernet Power Injector Specs
WatchGuard Part Number
Specification
AC Input Voltage Rating
WatchGuard Technologies, Inc.
802.3at PoE+ Injector with AC cord (US/FCC) (WG8599)
802.3at PoE+ Injector with AC cord (CE) (WG8600)
802.3at PoE+ Injector with AC cord (UK) (WG8601)
802.3at PoE+ Injector with AC cord (AUS) (WG8602)
IEEE 802.3at/af
100-240VAC
WatchGuard AP125 Hardware Guide
13