Hilti TE 6-A36 Operating Instructions Manual page 21

Observe the information printed in the operating instructions concerning operation, care and maintenance.
Observe the national health and safety requirements.
2.2 Chuck
TE‑C CLICK chuck
2.3 Switches
en
Speed control switch for smooth starting
Function selector switch
Forward / reverse switch
2.4 Grips
Vibration-absorbing, pivotable side handle with depth gauge
Vibration-absorbing grip
2.5 Protective features
Mechanical slip clutch
2.6 Additional electronic features of the power tool
The power tool is equipped with electronic overload protection. The power tool switches off automatically in the event
of overloading. When the control switch is released and then pressed again, the power tool immediately regains full
power.
In addition, the temperature of the power tool's electronics is monitored to ensure extra-long life. In the event of the
electronics overheating, the drive spindle will not rotate even when the control switch is pressed fully. The power tool
can be used again as soon as the temperature is within the permissible range.
2.7 Lubrication
Permanent lubrication (grease)
2.8 Items supplied as standard
1 Power tool
1 TE‑C CLICK chuck
1 Side handle with depth gauge
1 Operating instructions
1 Hilti toolbox (optional)
1 Cleaning cloth (optional)
1 Grease (optional)
2.9 Li‑ion battery charge state
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
NOTE
Indication of state of charge is not possible while the power tool is in operation or immediately after operation. If the
battery charge state LEDs blink, please refer to the information given in section 9, "Troubleshooting".
16
LEDs blink
-
-
-
-
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %