Output Mode - Signet 8350-1 Manual

Calibrate Menu
Display
(Factory settings shown)
Temp Units:
°C
Set:
Temperature
Loop Range: °C
0.0 → 100.0

Output Mode:

Low
Output Setpnt:
25.0
°C
Output Hys:
°C
Output Range:
25.0-45.0
Output PlsRate:
120 Pulses/Min
Last CAL:
2-10-09
6
Select Temperature units: °C or °F.
>
Provides a maximum 20 °C offset to match 8350 to external reference.
Enter "-999" to restore the original Factory calibration value.
Changes to this setting will become effective when the display exits the Calibrate menu.
Check the 2350 Sensor instructions for the range capability of your sensor.
> Be sure to modify this setting if you change the Temperature Units.
Select the desired mode of operation for the Open Collector output. Options available are Off,
> Low, High or Pulse. The signal may be disabled (Off) if not used.
In Low or High Mode, the Open Collector output will be activated when the temperature
> reaches this value. Be sure to modify this setting if you change the Temperature Units.
The Open Collector output will be de-energized at Setpoint ± Hysteresis, depending on High
> or Low Setpoint selection.
If the output is in PULSE mode, set the start and end point of the range and also set the
maximum pulse rate. (The maximum PULSE rate setting is 400 pulses per minute.)
>
The combined Output Range and Pulse rate settings shown here indicate:
"Start pulsing when the process value is 25° and increase the pulse rate up to the maximum
>
of 120 pulses per minute when the process value reaches 45°"
Use this "note pad" to record important dates, such as annual recertifi cation or scheduled
maintenance.
Description
8350-1 Temperature Transmitter