Ricoh OP-P1 Service Training page 105

Reload Temp.
Idling Start Temp.
Temp. Reading
(Thermistor)

Fusing temperature control keeps the hot roller temperature constant during
a print job at "D".

When the job is finished, the machine returns to standby mode "C" and is
ready to start the next job as soon as it is received.

If a new job is received within 30 sec. the machine starts the new job
immediately. If a new job is not received within 30 sec., the machine enters
Energy Save Mode 1 at "E" (the default for energy save mode 1 is disabled).

If a new job is received within 60 sec. the machine recovers rapidly and
starts printing. If a new job is not received within 60 sec. while the machine
is in Energy Save Mode 1, the machine enters Energy Save Mode 2. This
mode conserves power while the printer remains idle.
Slide 105
A: Stop (machine idle)
B: Start up
C: Ready (Standby)
D: Printing (paper feeding)
C: Ready (Standby)
E: Energy Save Mode 1 (Default: Machine idle 30 sec.)
F: Energy Save Mode 2 (Default: Machine idle for 60 sec.)
G: Recover from energy save mode
C: Ready (Standby)
Temperature Control (3)
Time
105
OP-P1/MF1 Training