Specifications - EUFAB 16542 Manual

Scope of supply
1 x Battery charger 2 x Cable holders

Specifications

Mains voltage input: 230V AC 50 Hz
Charging voltage: 12V DC
Battery: Pb-Battery min. 20Ah, max. 80 Ah
Weight: 1.8 kg
Legend
Safety Precautions
The warning triangle labels all instructions relevant for safety. Always comply with these, as non-observance may lead to injuries or
damage the device.
Only connect the device to a power socket installed according to regulations. The voltage has to correspond with the information on
the type plate of the device.
Do not pinch the mains cable and protect it from sharp edges, humidity, heat or oil. The mains cable cannot be replaced. The device
has to be scrapped if the cable is damaged.
Do not operate the device or pull the mains plug immediately if the cable is damaged or in the event of a suspected defect. In these cases, please
contact our technicians.
Pull the mains plug when the device is not being operated.
Keep the packaging material, particularly films and film bags out of reach of children. Risk of suffocation.
Remove all protective films from the device prior to start-up.
Place the mains cable in such a manner that it does not impede and that it cannot be unplugged accidentally.
Disconnect the battery charger from the power supply after the charging process.
Store the charger in a place which is out of the reach of children and unauthorised persons.
Do not operate the device close to combustible material or in an explosive environment.
Always wear suitable work clothing, protective gloves and safety glasses. Battery acid is caustic! Immediately rinse any acid splashes
with lots of water and consult a physician, if required. If battery acid has come in contact with eyes, rinse immediately under running
water for at least 10 minutes and consult a physician.
Do not cover the charger as this may lead to overheating and thus damage to the device. During operation, do not place the charger on an insu-
lating surface (e.g. polystyrene) - risk of heat accumulation!
If you would like to charge a motor vehicle battery in an in-situ position, first park the vehicle securely, then pull the parking break and switch
off the engine. Disconnect the battery from the electrical distribution system of your vehicle. For this purpose, read the manual of your vehicle
or ask your specialist workshop.
Only hold the power cable at the power plug when disconnecting from the power socket.
Do not expose the charger to fire, heat and long-temperature impact of more than +40°C!
Keep these operating instructions and pass them on to other users.
Operating instructions
Preparation of the battery
Clean the battery poles from dust and corrosion residue. Only for open batteries: replenish distilled water up to the minimum fill level. Leave the
4
1 x Spare fuse 7.5 A 1 x Operating instructions
Power consumption:
Charging power:
Ambient temperature:
Fuse:
64W
6 A RMS (3,5 A)
-15 °C to + 40 °C
Blade-type fuse 7.5 A