Replacing The Sfp+ Unit On The Hba - Sun Microsystems StorageTek SG-XPCIE1FC-QF8-Z Installation Manual

5. To exit the QLogic Fast!UTIL, press the Escape key, highlight Exit Fast!UTIL,
and press Enter.
The following QLogic Fast!UTIL menu is displayed.
----------------------------------------------------------
Adapter Type I/O Address
QLE2562
----------------------------------------------------------
The following QLogic Fast!UTIL menu is displayed.
Exit Fast!UTIL
----------------------------------

Replacing the SFP+ Unit on the HBA

The Small Form Factor Pluggable (SFP+) optics unit on this card is considered a part
of the card, NOT as a separate field replaceable unit (FRU). Therefore, in the event
that the SFP+ unit malfunctions, you must return the entire card in order to receive
a replacement SFP+ unit. Always return any malfunctioning card with the SFP+ unit
attached. For information about removing the card from a system in order to return
it, see "To Remove the HBA" on page
QLogic Fast!UTIL
Selected Adapter
Slot
9400 01
Fast!UTIL Options
Configuration Settings
Scan Fibre Devices
Fibre Disk Utility
Loopback Data Test
Select Host Adapter
Exit Fast!UTIL
QLogic Fast!UTIL
Reboot System
Return to Fast!UTIL
24.
Chapter 2
Bus Device Function
02 01
Hardware Installation and Removal
1
23