Remote Control Unit - Samsung DVD-SH855M Instruction Manual

HDMI output Jitter.
Check your TV system setup correctly.
Checkpoint 1
Please refer to the user's manual of your TV.
Checkpoint 2

Remote Control Unit

The remote control doesn't work.
Point the remote control at the remote control
Checkpoint 1
sensor on your HDD & DVD Recorder. Allow for
proper distance. Remove obstacles between
your HDD & DVD Recorder and the remote
control.
Check whether the batteries are drained.
Checkpoint 2
Check the TV/DVD selection button setting.
Checkpoint 3
Check whether TV, DVD or HDD control button
Checkpoint 4
is selected or not.
Other
I forgot my password for parental supervision.
Press and hold the PROG (
Checkpoint 1
the front panel of the Recorder for more than 5
seconds with no disc in the unit. All settings
including the password will revert to the factory
settings. Do not use this unless absolutely
necessary.
(Note that this function is possible only when
no disc is inserted.)
Is it possible to change a subtitle and an audio signal on
a recorded disc?
A recorded disc is played with only the subtitle
Checkpoint 1
and the audio signal which were selected
during recording.
Other problems.
Read the table of contents and then fi nd and
Checkpoint 1
read the section describing your problem,
follow the instructions given.
Plug your HDD & DVD Recorder off and on.
Checkpoint 2
If the problem still persists, contact a nearby
Checkpoint 3
Samsung service centre.
) buttons on
English - 106