Dust Collection; Operation - Clarke DWS180 Operation & Maintenance Instructions Manual

DUST COLLECTION

1. Ensure the sander is switched off.
2. Connect hose onto the dust
extract port on the underside of
the sander trigger handle.
3. Connect opposite end of hose
onto dust collection bag.
NOTE: The dust bag must be
emptied regularly:- do not
wait until it is completely full.
The dust bag is emptied as follows.
1. Ensure the sander is switched off.
2. Gently remove the dust bag from
the hose.
3. Take the dust bag to the dustbin
and slide the clip off the bag,
empty the bag into the bin.
4. Reassemble the dust bag and clip
and fit back on to the hose.

OPERATION

1. Plug into the mains socket and
switch on,
2. Set speed of sander, see page 11
3. Place the sanding disc on the
workpiece.
• Hold the sander firmly with both
hands.
4. Squeeze the trigger.
• Allow to get up to speed
before working gently across the workpiece until smooth.
5. Release the trigger.
• Wait until the motor has stopped fully before putting the sander
down.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
10